Form1+ Design Limits

Form 1+ Model Design

The Form 1+ design limits are found at FormLabs site [1]. Since these are in metric units, this page has been added with the imperial units. These parameters use standard 3D nomenclature.

• Minimum Supported Wall Thickness: 0.4 mm [0.016 in]
• Minimum Unsupported Wall Thickness: 0.6 mm [0.024 in]
• Maximum Unsupported Overhang Length: 1.0 mm [0.039 in]
• Minimum Unsupported Overhang Angle: 19°
• Maximum Horizontal Support Span/Bridge: 21 mm (5 mm width, 3 mm Thick) [0.945 in]
• Minimum Vertical-Wire Diameter: 0.3 mm [0.012 in] @ 7 mm [0.276 in] Tall to 1.5 mm [0.059 in] @ 30 mm [1.181 in] Tall
• Minimum Embossed Detail: 0.1 mm [0.004 in]
• Minimum Engraved Detail: 0.4 mm [0.016 in]
• Minimum Clearance: 0.5 mm [0.020 in]
• Minimum Hole Diameter: 0.5 mm [0.020 in]
• Minimum Drain Hole Diameter: 3.5 mm [0.138 in]